Water pond filters are very important to any fish pond, most people often only think about the decoration and the surroundings of the pond itself. To maintain a good quality healthy looking pond you need to have water pond filters in place, the ones that can cope with the size and volume of water in order to keep the pond clean and healthy for you're fish to survive. So when you build your fish pond, you must have the correct pump and filter installed, as these two powerful tools do a tremendous job in removing dirt, leaves, fish waste and other debris that cause bacteria and dangerous levels of pH in the water.
There are lots of different types and variations of water pond filters available on market theses days, like for instance backwashing filters, pressure filters, UV filters and bio filters. To know which type that suits your pond the best is to do a little research on the internet and do some consulting it with the experts. Once you've chosen your water pond filters you will also need to choose the best pump, there are two types of pumps that you can use, the ones that are submersible, and the ones that are housed outside the pond, but both types do a fantastic job.
Submersible pumps are often used to generate fountains and other water features as well as feeding the main filter itself. They are very easy to install and operate, and don't need to be primed or anything like that. These types of pumps have a strainer on the inlet side to prevent fish and debris being sucked into the moving parts. External surface pumps are more powerful and are usually a lot larger and more expensive than the submersible types. If you want to pump up to a waterfall of any distance, then you will need to use a surface pump.
When linking your pump to the water pond filters, make sure that they are both compatible with each other and that the capacity of the pump is suitable for the volume of water in your fish pond. You can do this by checking the output of the pump which is given in gallons (or litters) per hour. This terminology can be a little confusing, but a good rule of thumb is to make sure that the pump can circulate all of the pond water through the filter within one to two hours.
If you want the pump to feed a filter and fountain at the same time, then you will need to consider the effect of the water spurting out of the fountain, the greater the maximum head, the higher the water will spray into the air thus reducing the water circulation time. Majority of pond pumps are powered by electricity, and the growing trend towards solar power has lead to an increase of solar powered pumps. But please consider this, most solar powered pumps are only suitable for fountains and smaller water features, and are not suitable for water pond filters.
No comments:
Post a Comment